Well, here's a bit of what I've got to fix: [imgur.com]
It reads two endstops pressed when only one has been. It seems to be affecting the Z axis, then somehow seems to "infect" the Y axis switch.
for now, I don't have any pics of the board, but I don't have any LCD board, and I'm running Marlin, and I have tried to re-upload the config.h with different pull-up configs on the endstops, just to see if that would fix it... long story short, it didn't and I"ve since reconfigured the board back to the way it was before.
I was out of town for a buisness trip for three weeks, so I hadn't printed since the begining of June... and I had no probelms then. If I could get some help, I would appreciate it :)
(I've got something that I want to print for this weekend!) Thanks! Chris, AKA Skidd
It reads two endstops pressed when only one has been. It seems to be affecting the Z axis, then somehow seems to "infect" the Y axis switch.
for now, I don't have any pics of the board, but I don't have any LCD board, and I'm running Marlin, and I have tried to re-upload the config.h with different pull-up configs on the endstops, just to see if that would fix it... long story short, it didn't and I"ve since reconfigured the board back to the way it was before.
I was out of town for a buisness trip for three weeks, so I hadn't printed since the begining of June... and I had no probelms then. If I could get some help, I would appreciate it :)
(I've got something that I want to print for this weekend!) Thanks! Chris, AKA Skidd