Hi all
My 2011 Sanguinololu 1.3a needs new firmware. It arrived with bootloader set to 38400 baud.
Initially I used Arduino 0023 on windows to load sprinter, this had no problems. However that PC died.
Now I have Linux Mint 17, and Arduino 1.0.5 (from software center). I found the Google Code sanguino software and Sanguino-0101r1.zip, and successfully compiled Sprinter.
However, I get invalid device signature.
[reprap.org]
Is the Atmega644P responding, should I use the avrdude -F optoion to override the signature check, or would this kill my microcontroller?
Thanks!
My 2011 Sanguinololu 1.3a needs new firmware. It arrived with bootloader set to 38400 baud.
Initially I used Arduino 0023 on windows to load sprinter, this had no problems. However that PC died.
Now I have Linux Mint 17, and Arduino 1.0.5 (from software center). I found the Google Code sanguino software and Sanguino-0101r1.zip, and successfully compiled Sprinter.
However, I get invalid device signature.
[reprap.org]
Is the Atmega644P responding, should I use the avrdude -F optoion to override the signature check, or would this kill my microcontroller?
Thanks!