Azteeg X1 not running G Code (17 replies)

I have an Azteeg X1 and it is not running my G Code correctly. It works a bit then stops, or works on one axis but not on the other, but then after a reset switches. Then my Z axis goes down no mater what polarity I send it.

However when I run test code from the Arduino interface it runs the steppers back and forth just fine.

I have tried Marlin, and Sprinter. Both do similar things when told to run G Code.

I am using the Universal Gcode sender, as the windows one does not seem to work for me.

Any Ideas on what my issue is?

Thanks a bunch