Hello,
I have a problem with my Sanguinololu 1.3a based printer. It seems to not take power from the power supply for some reason. It takes power from usb just fine and everything lights up but as soon as I plug in the power supply everything goes dark and nothing works. I wanted to reroute the power to make it go through wires instead of the board pathways (I suspect conductivity problems on the board), but I have no clue how to do that correctly and which pins to connect with each other.
Does anyone have any idea what might be the cause of the problem, or have any other ideas how I can fix this?
Power supply is working correctly.
Ebdac
I have a problem with my Sanguinololu 1.3a based printer. It seems to not take power from the power supply for some reason. It takes power from usb just fine and everything lights up but as soon as I plug in the power supply everything goes dark and nothing works. I wanted to reroute the power to make it go through wires instead of the board pathways (I suspect conductivity problems on the board), but I have no clue how to do that correctly and which pins to connect with each other.
Does anyone have any idea what might be the cause of the problem, or have any other ideas how I can fix this?
Power supply is working correctly.
Ebdac