I'm using Windows7, a Sanguinololu 1.3a and prontoface on a machine I have built myself.
I have had this machine printing out successfully in the past but now it refuses to work.p
When I attempt to connect the 3D printer to Prontoface the screen comes up on the computer but the graphics for moving the
3 axes remains grayed out IE. The machine is not connecting. I am using COM3 and 115200 Baud rate.
Power supply is OK. Red LED comes on.
When I hit the connect button Prontoface says "connecting " then every second it prints M105 on successive lines. (This is trying to read the
Temperature sensor every second).
I have checked all of the wiring connections and tried new stepsticks and have spent LOTS of time trying to find the problem.
I don't know if this is a software problem; a wiring disconnect or short or a driver problem or anything else.
Has anyone experienced a similar problem and has found the solution.
I would appreciate any help.
Many thanks, Keith.
I have had this machine printing out successfully in the past but now it refuses to work.p
When I attempt to connect the 3D printer to Prontoface the screen comes up on the computer but the graphics for moving the
3 axes remains grayed out IE. The machine is not connecting. I am using COM3 and 115200 Baud rate.
Power supply is OK. Red LED comes on.
When I hit the connect button Prontoface says "connecting " then every second it prints M105 on successive lines. (This is trying to read the
Temperature sensor every second).
I have checked all of the wiring connections and tried new stepsticks and have spent LOTS of time trying to find the problem.
I don't know if this is a software problem; a wiring disconnect or short or a driver problem or anything else.
Has anyone experienced a similar problem and has found the solution.
I would appreciate any help.
Many thanks, Keith.