Hi everyone, I got my first printer recently and I'm trying to upload Marlin to it to enable autolevelling.. I can control the printer through USB (pronterface) but I'm having trouble flashing the software.
I've tried ReprapPro's version of Marlin, configured as per their tutorial, with board set to 'Melzi 1284p 16mhz'
I've tried Marlin 1.0.x, configured as per Tom's firmware guide, with board set to 'Sanguino W/ ATmega1284p 16mhz'
I've tried the manufacturer's provided preconfigured repetier firmware
In all cases Arduino IDE compiles the code fine but on upload it gets stuck at "Uploading..."
I've tried ReprapPro's version of Marlin, configured as per their tutorial, with board set to 'Melzi 1284p 16mhz'
I've tried Marlin 1.0.x, configured as per Tom's firmware guide, with board set to 'Sanguino W/ ATmega1284p 16mhz'
I've tried the manufacturer's provided preconfigured repetier firmware
In all cases Arduino IDE compiles the code fine but on upload it gets stuck at "Uploading..."