Hello everybody!
Let’s give it a quick introduction: I am owner of an orcabot 0.43 since some weeks now. I made it work and print and also started modding it.
Now I am at the point where I want to change some firmware settings. Unfortunately Igor the printer just as it is, no sifteare,, no docu and no one to ask. I did not find a single picture that matches my Bord. I guess it is a gen 6 electronic of some kind.
Is there any intelligence out there to tell me
I thing I red something about backup. I will of course try that because the printer is working with whatever firmware is on it now.
Enclosed is a picture of the board. Thanks for any ideas on that thing.
...
...
Picture size is quite limited, so here is a link to the picture:
[www.dropbox.com]
Let’s give it a quick introduction: I am owner of an orcabot 0.43 since some weeks now. I made it work and print and also started modding it.
Now I am at the point where I want to change some firmware settings. Unfortunately Igor the printer just as it is, no sifteare,, no docu and no one to ask. I did not find a single picture that matches my Bord. I guess it is a gen 6 electronic of some kind.
Is there any intelligence out there to tell me
- What board that is
- If Marlin 1.1.8 will run on it
- What sanguino settings I need to choose in Arduino software for flashing
I thing I red something about backup. I will of course try that because the printer is working with whatever firmware is on it now.
Enclosed is a picture of the board. Thanks for any ideas on that thing.
...
...
Picture size is quite limited, so here is a link to the picture:
[www.dropbox.com]