Just looking at section 17.2 of the ATmega1284P specs here [www.atmel.com]
It appears it should support 1M baud rate, 4x the default setting in my Marlin firmware. Is it safe to just change this and try it? Why is the default so low in the firmware?
My motivation is the slow upload speed to the SD card, and the desire to not have to keep popping it physically into my computer.
Marcos
It appears it should support 1M baud rate, 4x the default setting in my Marlin firmware. Is it safe to just change this and try it? Why is the default so low in the firmware?
My motivation is the slow upload speed to the SD card, and the desire to not have to keep popping it physically into my computer.
Marcos