Hi,
I wanted to connect the SainSmart 2004 Smart LCD Controller to my RepRapPro Huxley.
My problem is, that one pin is used. It´s the bed heater control.
(This pin is labelled D10: it has a 5V signal when the hot bed needs to heat up, otherwise 0V).
[reprap.org]
What do I have to do to run my Huxley without this D10 pin?
Or can I change it to a free pin? (Didn´t find a free pin)
Thx LG MaxTex
I wanted to connect the SainSmart 2004 Smart LCD Controller to my RepRapPro Huxley.
My problem is, that one pin is used. It´s the bed heater control.
(This pin is labelled D10: it has a 5V signal when the hot bed needs to heat up, otherwise 0V).
[reprap.org]
What do I have to do to run my Huxley without this D10 pin?
Or can I change it to a free pin? (Didn´t find a free pin)
Thx LG MaxTex