Sanguinololu 1.3a Huxley connection problem (4 replies)

Hi all,

I posted this in the Huxley section but figured it should maybe be in the Sanguinololu section. I apologize if I shouldn't do that.

I recently was given a Huxley 3d printer - the one from the original kickstarter.

I am trying to connect it to the computer. But windows simply does not pick it up. It doesn't recognize that anything is connected via the USB. The red light does come on, on the Sanguinololu 1.3a board.

I really don't know what I am doing to be honest, but I assume that there is probably something wrong with the board? I have tried to install all the drivers that I can find but no luck.

Any ideas would be greatly appreciated!

Thanks,

Damian